Brother NV4000D Service Manual page 197

Module
12
Thread cutter frame assembly attachment
1. Insert the 2 collars 3 between the thread cutter frame assembly 1 and the
motor holder assembly 2.
*Key point
• Insert the collars into the screw holes.
2. Attach the thread cutter frame assembly 1 to the motor holder assembly
2 with the 2 screws 1.
*Key point
• Pass the lead wire between the thread cutter lever shaft 4
and the collar 3.
• Thread the 2 screws 1 through the collar 3, and then tighten
them.
• Engage the positioning hole on the thread cutter lever shaft 4
with that on the thread cutter frame assembly 5.
• Insert the pin of the thread hook assembly 6 on the rear of the
thread cutter frame assembly into the slot on the thread cutter
lever 7.
3. Tie the lead wires with a band.
*Key point
• Refer to "Wiring procedures".
Start movie clip (CD-ROM version only)
1
Thread cutter module
Screw, Bind
M4X20
1.18 – 1.57 N
Color; Silver
1
1
4
Torque
·
m
3 1
2
7 5 6
3 - 65