Brother NV4000D Service Manual page 200

Module
2
Side feed gear attachment
1. Place the side feed washer 1 onto the calking shaft 3 of the S pulse motor
holder assembly 2.
2. Place the side feed washer 1 onto the calking shaft 3 of the S pulse motor
holder assembly 2.
3. Attach one end of the spring
the side feed gear 5 into the side feed plate 4.
*Key point
• Engage the tab at the end of the side feed washer with the
notch on the end of the side feed plate.
4. Attach the other end of spring
*Key point
• Attach the spring
round hole, and the end on the S feed gear side to the spring
hook.
5. Engage the side feed gear 5 with the S pulse motor gear 6.
*Key point
• Align the mark 8 on the side feed gear with the mark 7 on
the S pulse motor gear.
6. Attach the S stopper 9 to the S pulse motor holder assembly with the
screw 1.
*Key point
• Engage the positioning tab on the S pulse motor holder
assembly with the positioning hole on the S stopper.
7. Attach the rubber ; to the rubber attachment section of the S pulse motor
holder assembly 2.
Start movie clip (CD-ROM version only)
1
S41
3 - 68
Side feed module
to the side feed gear 5, and then insert
S41
to the side feed plate 4.
S41
S41
end on the side feed plate side to the
Screw, Bind
M3X6
Color; Silver
20
SPRING, EXTENTION
3.6
1
Torque
·
0.79 – 1.18 N m
XA9508***
3 2
4
S41
8 7 6
5
1
9 :
5