Brother NV4000D Service Manual page 192

Module
1
Z pulse motor assembly attachment
1. Attach the Z pulse motor assembly 1 to the motor holder assembly 2
with the 2 screws 1.
*Key point
• Position the Z pulse motor assembly so that the PCB is at the
lower right section.
2. Connect the lead wire connector to the PCB of the Z pulse motor assembly.
3. Apply 1 or 2 drops of Turbine Oil #100 to the bushing of the Z pulse
motor.
Apply Turbine Oil #100 to the bushing of the Z pulse
motor.
Start movie clip (CD-ROM version only)
1
3 - 60
Thread cutter module
Screw, Bind
M3X4
Color; Silver
1 - 2 drops
Torque
·
0.78 – 1.18 N m
1
2 1