Brother NV4000D Service Manual page 249

Module
15
Release plate assembly attachment
1. Apply a small bead of MOLYKOTE EM-30L to the calking shaft at the
end of the release plate assembly 1.
2. Insert the release plate assembly 1 into the shaft hole on the unit holder.
*Key point
• Move the Z zigzag cam 2 to the position of the photo.
3. Attach the retaining ring (E2) to the calking shaft of the release plate
assembly 1 from the rear of the unit holder.
Apply MOLYKOTE EM-30L to the calking shaft at the
end of the release plate assembly.
Start movie clip (CD-ROM version only)
Needle-presser module
Small bead
1
1 2
Retaining ring E2
3 - 117