Brother NV4000D Service Manual page 178

Main unit
7
Front cover assembly (LCD ASSY attachment)
1. Place the touch panel 1 in the LCD holder 3, with the lead wire 2 of the
touch panel 1 on the left side.
2. Attach front cover spacer B 4 (2 locations) to LCDKCG089 5, and then
remove the transparent film from the LCD.
NOTE
• Carefully attach front cover spacer B 4.
Do not allow it to extend as far as the LCD.
3. Reverse LCDKCG089 5, and place it on the touch panel 1.
4. Attach LCD presser A 6 to the left side of the LCD holder with the 2
screws 1.
*Key point
• Tighten the screws 1 in the following order: 1-1 (temporarily
tighten), 1-2 (fully tighten).
5. Attach LCD presser B 7 (4 locations) to the center and right side of the
LCD holder with the screws 2.
*Key point
• Tighten the screws 2 in the following order: 2-1, 2-2, 2-3,
and 2-4.
6. Insert the LCD cable (FFC: SML2CD) 8 into the connector of
LCDKCG089 PCB 9.
*Key point
• Insert the LCD cable 8 into the connector with the blue tag
facing up.
Start movie clip (CD-ROM version only)
1
2
3 - 46
Main parts
Taptite, Bind B
M3X8
Color; Gold
Taptite, Bind B
M3X8
Color; Gold
Torque
·
0.39 – 0.79 N m
Torque
·
0.39 – 0.79 N m
1 2 3
1-2 2-1 7 2-3
6
2-2
1-1
4
5
9
8
2-4