Brother NV4000D Service Manual page 201

Module
3
Side feed adjust plate attachment
1. Apply a bead of MOLYKOTE EM-30L to the shaft hole on the edge of the
side feed adjust plate 1.
2. Attach plate spring B 2 and then the washer 3 to the screw 1.
3. Insert the shaft on the rear of the side feed arm assembly 5 into the shaft
hole 4 on the side feed adjust plate 1 and hold them in place by hand, and
then tighten the screw 1.
*Key point
• Tighten the screw 1 after plate spring B and the washer have
been attached.
• Engage the positioning tab on the side feed adjust plate with
the notch on plate spring B.
Apply MOLYKOTE EM-30L to the shaft hole on the
edge of the side feed adjust plate.
1
4
Side feed arm assembly attachment
1. Apply a bead of MOLYKOTE EM-30L to the shaft hole on the side feed
plate 1.
2. Attach plate spring A 2 to the screw 1.
3. Insert the shaft of the side feed arm assembly 3 into the shaft hole on the
side feed plate 1 and hold them in place by hand, and then tighten the
screw 1.
*Key point
• Tighten the screw 1 after plate spring A has been attached.
• Engage the positioning tab on the side feed washer with the
notch on plate spring A.
Apply MOLYKOTE EM-30L to the shaft hole on the
side feed plate.
1
Side feed module
Screw, Bind
M3X5
0.79 – 1.18 N
Color; Silver
Screw, Bind
M3X6
0.79 – 1.18 N
Color; Silver
1
Bead
Torque
·
m
Bead
Torque
·
m
4 5
2 3
1
1
3 2 1
3 - 69