Brother NV4000D Service Manual page 241

Module
5
T cam attachment
1. Place the polyester slider 1 onto the T cam attachment shaft 2 of the unit
holder.
2. Apply a small bead of MOLYKOTE EM-30L to the T cam attachment
shaft 2.
3. Apply a light covering of MOLYKOTE EM-30L to the cam groove on the
T cam 3.
4. Apply a light covering of MOLYKOTE EM-30L to the gear of the T cam
3.
5. Place the T cam 3 onto the T cam attachment shaft 2.
*Key point
• Position the T cam with the cam groove down.
• Press the cut face of the T cam against the wall of the unit
holder 4 to insert the T cam.
Apply MOLYKOTE EM-30L to the T cam attachment shaft.
Apply MOLYKOTE EM-30L to the cam groove on the T cam.
Apply MOLYKOTE EM-30L to the gear of the T cam.
Start movie clip (CD-ROM version only)
6
Shaft attachment
1. Insert the shaft 1 from the rear of the unit holder.
*Key point
• Fully insert the shaft.
Needle-presser module
Light covering
Light covering
Small bead
2
1
3
4
1
3 - 109