Brother NV4000D Service Manual page 128

Embroidery
27
YPM lead wire assembly removal
1. Remove the YPM lead wire assembly 1 from the connector of the Y pulse
motor 2.
28
Cord clip removal
1. Slide the left and right cord clips 1 to the right to remove them.
2. Remove the FFC cord 2 from the cord clip 1 on the right.
29
Y carriage assembly removal
1. Remove the 2 screws 1 from the Y carriage assembly 1.
*Key point
• Do not remove the Y carriage assembly 1 at this point.
2. Remove the stop ring (10.69) from the inside of the Y guide shaft 2.
3. Pull the Y guide shaft 2 to the left to remove it.
4. Slide the Y carriage assembly 1 to the left to remove it from the Y slider
3.
5. Remove the stop ring (10.69) from the outside of the Y guide shaft 2, and
then remove the washer 4 and spring washer 5 from the Y guide shaft
2.
Start movie clip (CD-ROM version only)
2 - 106
Main parts
2
1
1
2
Stop ring (10.69)
2 1
2
Stop ring (10.69)
1
3
4 5