Brother NV4000D Service Manual page 204

Module
3
Feed adjuster assembly attachment
1. Place spring onto the shaft of the feed adjuster 1.
S14
*Key point
• Place spring
2. Apply a small bead of EPNOC AP (N)0 to the shaft of the feed adjuster 1.
3. Insert the shaft of the feed adjuster 1 into the bushing supporter assembly
2.
4. Attach the feed adjuster assembly 3 to the inside of the base plate with the
3 screws 1.
*Key point
• Engage the positioning tab on the feed adjuster assembly with
the positioning hole on the base plate.
5. Apply a small bead of EPNOC AP (N)0 to the operating section of the
rectangular slide 4 of the feed adjuster assembly 3.
Apply EPNOC AP (N)0 to the shaft of the feed adjuster.
Apply EPNOC AP (N)0 to the operating section of the
rectangular slide of the feed adjuster assembly.
Start movie clip (CD-ROM version only)
1
S14
3 - 72
Feed/rotary hook module
S14
from the end with the smaller diameter.
Screw, Bind
M4X6
Color; Silver
9.9
8.8
5.5
Small bead
Small bead
Torque
·
1.18 – 1.57 N m
SPRING
XC2531***
S14
1
2
1
3
4