Brother NV4000D Service Manual page 179

Main unit
8
Front cover assembly (SV keytop attachment)
1. Attach the SV joint plate 1 to the rear of the front cover.
2. Attach the SV keytop 2 to the hole on the SV joint plate 1 from outside
the front cover.
9
Front cover assembly (LCD holder assembly attachment)
1. Pass the touch panel's lead wire, LCDKCG089's lead wire, and the LCD
cable through the holes (3 locations) on the LCD holder assembly section
of the front cover.
2. Attach the LCD holder assembly 1 to the LCD holder assembly
attachment section on the front cover.
*Key point
• Set the right hooks (3 locations) of the LC holder assembly 1
into the LCD holder assembly attachment section, and then
attach the left hooks (2 locations).
3. Tighten the 4 screws 1 from the inside of the front cover.
*Key point
• Tighten the screws 1 in the following order: 1-1, 1-2, 1-3,
and 1-4.
Start movie clip (CD-ROM version only)
1
Main parts
Taptite, Bind B
M3X8
0.39 – 0.79 N
Color; Gold
Torque
·
m
1-2
1 1
2
1
1-3 1-1 1
1-4
3 - 47