Table of Contents
Advertisement
Figure 27. Removing the drive from the drive carrier
Next steps
1.
Install the drive into the drive
Installing the drive into the drive carrier
Prerequisites
1. Follow the safety guidelines listed in
2. If installed,
remove the front
3.
Remove the drive
blank.
Steps
1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips #1 screwdriver, replace the screws to secure the drive to the drive carrier.
NOTE:
If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screw driver to install the drive.
NOTE:
When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-pounds.
NOTE:
Use the screws shipped with the drive carrier to secure the drive to the drive carrier.
carrier.
Safety
instructions.
bezel.
Installing and removing system components
31
Advertisement
Table of Contents
