Table of Contents
Advertisement
98 |
SPECIFIC INSTRUCTIONS
ATTENTION!
The figures mentioned in the chapters are shown on the initial pages of this manual.
APPLIANCE DESCRIPTION
Sturdy stainless steel structure with 4 feet that can be
adjusted in height. External coating made in 18/10
chromium-nickel steel. The plate is heated by tubular
chromium-plated steel burners resistant to thermal
or mechanical stresses. The temperature regulation is
provided by the valve and safety devices.
EN
Location
The appliance should be installed in a well ventilated room
and, if possible, under a range hood.
The appliance can be installed on its own or alongside
other equipment. A minimum distance of 150 mm around
the sides and back should be maintained.
The walls near the appliance (walls, decorations,
kitchen cabinets, decorative finishes, etc.) must be
made of non-flammable material.
Place the appliance on a table or on a board made of non-
flammable material. Before connecting the appliance to
the gas supply, check the data plate to make sure that the
appliance is fitted for the type of available gas. If not, see
the paragraph "Running appliances on other types of gas".
Law provisions, technical regulations and directives
Before installing, check that the following provisions are
met:
- UNI CIG 8723 regulation
- building regulations and local fire prevention
measures;
- accident prevention regulations in force;
- local Gas Board regulations;
- CEI provisions in force;
- Fire Brigade provisions.
Assembly, installation and maintenance must all be
done by contractors authorized by the local Gas Board
in accordance with the regulations in force. Before doing
anything else, contact your Gas Board.
Installation procedure
To level the appliance correctly, adjust the height of the
four adjustable feet.
Gas connection
The 1/2" G gas pipe union can either be permanently fixed
or detached by using a standard adaptor. If a flexible hose
PREPARATION
INSTALLATION
MOD.
N°:
Qn
V
kW:
Hz: 50/60
is used, it must be stainless steel and in conformity with
regulations. After completing the connection, check for
leaks by using a special leak-detector spray.
Exhaust system
The appliances must be positioned in locations adapted
with a system for discharging the products of combustion
in respect of how much is prescribed by the norms of
the installation. Our appliances are classified (see the
"TECHNICAL DATA" table) as:
"A1" gas appliances
They are not designed for the connection to a line for the
discharge of products of combustion.
These appliances must discharge the products of
combustion into appropriate hoods, or similar devices,
connected to a flue of proven efficiency, or they may be
connected directly to an outdoor vent.
If such an arrangement is not possible, the unit may be
connected to an air exhaust system which leads directly
outdoors, having a capacity no lower than required;
see the "TECHNICAL DATA" table, plus the air exchange
necessary, in order to make operators comfortable.
Electrical connection
Before connecting the appliance to the mains, check the
following:
- the network voltage corresponds to the values shown
on the plate
- grounding is efficient
- the connecting cable is adequate to the power absorbed
by the appliance.
Moreover, upstream the appliance, a device with a
contact opening of at least 3 mm must be fitted in order
to disconnect the appliance in an omnipolar way. Safety
switches can be used for this purpose. The omnipolar
switch must be close to the appliance, be homologated
and have a section suitable for the appliance.
The cable must be at least an H07 RN-F.
The YELLOW-GREEN ground cable must not be cut.
Unipotential
The appliance must be connected to a unipotential
system. The foreseen terminal is located close to the cable
input. It is marked by a label
IPX2
Hide quick links:
Advertisement
Table of Contents
