PLANET ECLIPSE EGO TEN Operator's Manual page 66

tHe eGo10 on/off PurGe
sYstem (ooPs)
WARNING
WarninG: de-Gas Your marKer, discHarGinG anY
stored Gas in a safe direction, and remoVe tHe
barrel, loader, air sYstem and anY Paintballs
to maKe tHe marKer easier and safer to WorK
having disconnected the macroline hose from the fitting
on the OOPS body, unscrew the OOPS knob from the
OOPS body
moisture from the OOPS knob and the threaded section of
the OOPS body.
Use an appropriately sized hex key to push the OOPS pin
out of the OOPS body
the OOPS insert using a pair of needle nosed pliers
fiGure 18.3).
Clean and check the condition of the two 008 Nbr70
o-rings on the outside of the OOPS insert, replacing as
necessary
66.
on.
. Clean off any dirt, debris or
(see fiGure 18.1)
(see fiGure 18.2)
(see fiGure 18.4) .
and then remove
(see
fiG 18.1
fiG 18.2
fiG 18.3 fiG 18.4