PLANET ECLIPSE EGO TEN Operator's Manual page 38

ramP setuP
tHe ramP settinGs menu
This menu is only available when ramping has been
selected with the
list of parameters that control the way in which the Ego10
ramps, as shown below.
tYPe
tHe ramP tYPe Parameter
This parameter is used to select the ramping
style and has the following choices (see
opposite):
38.
parameter and comprises a
FirE MODE
> steP: Step ramping will cause the Ego10 to shoot in
semi-automatic until a number of trigger pulls, set by
SEMi SHOtS , have been made at a minimum pull rate, set
by . At this point the rate of fire will step up to the
KiCK in
maximum rate of fire as set by
loader speed if the parameter is set to off).
rOF Cap
ramping is maintained as long as the user continues to
pull the trigger at a required rate set by
> linear: linear ramping will cause the Ego10 to shoot in
semi-automatic until a number of trigger pulls, set by
, have been made at a minimum pull rate, set by
SHOtS
. At this point the rate of fire will equal the rate of trigger
in
pulls increased by the percentage specified by
maximum rate of fire as set by
on. ramping is maintained as long as the user continues to
pull the trigger at a required rate set by
> cancel: Editing is cancelled and no changes are made
to the parameter.
rate
tHe linear ramP rate Parameter
The parameter is only available when
ramping is selected and is used to set the
percentage increase in rate of fire over rate
of trigger pulls.
For example, if the user is pulling the trigger
at a rate of 10 pulls per second and the
parameter is set to 50% then the rate of fire
is 10 plus 50% extra which is 15 balls per
second.
This parameter can be set between 0 and 100% in 10%
increments.
(or the maximum
BS On rOF
.
SUStain
SEMi
KiCK
up to a
ratE
, if the is
BS On rOF rOF Cap
SUStain .
LinEar
ratE