Download Print this page

PLANET ECLIPSE EGO TEN Operator's Manual page 24

Advertisement

adJustinG tHe VelocitY
when using your Ego10, you may wish to change the
velocity at which your Ego10 is firing. This is done by
inserting a 1/8" hex key into the adjuster screw at the
bottom of your Ego10 inline regulator and adjusting it
accordingly
screw clockwise you decrease the output pressure of the
inline regulator and consequently the velocity, by turning
the adjuster screw counter clockwise you increase the
output pressure of the inline regulator and consequently
the velocity. On the bottom of the inline regulator there are
engraved arrows to illustrate which direction to turn the
hex key to make the relevant adjustment.
note: AFTEr EACh ADjUSTMENT FirE TwO ClEAriNg
ShOTS TO gAiN AN ACCUrATE vElOCiTy rEADiNg. NEvEr
adJustinG tHe lPr
Pressure
when using your Ego10, you may wish to change the
output pressure of your lPr. This is easily done by inserting
a 1/8" inch hex key into the adjuster screw at the front
and adjusting it accordingly
we recommend that the lPr screw be left set 2 turns in
(clockwise) from the screw being flush with the front of the
lPr cap.
by turning the adjuster screw clockwise, you decrease the
output pressure of your lPr and consequently reduce the
pressure driving your rammer back and forth. by turning
the adjuster screw counter clockwise, you increase the
output pressure of your lPr and consequently increase the
pressure driving your rammer back and forth.
note: TUrNiNg ThE ADjUSTEr SCrEw iN TOO FAr will
24.
(see fiGure 7.1).
by turning this adjuster
ExCEED 300FPS.
(see fiGure 7.2).
PrEvENT ThE EgO10 FrOM FiriNg.
however
fiG 7.1
fiG 7.2

Advertisement

loading
Need help?

Need help?

Do you have a question about the EGO TEN and is the answer not in the manual?

This manual is also suitable for:

Ego 10