Advertisement

Quick Links

01
PLANET ECLIPSE: GTEK M170R
USER MANUAL / ENGLISH
GTEK M170R

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GTEK M170R and is the answer not in the manual?

Questions and answers

Summary of Contents for PLANET ECLIPSE GTEK M170R

  • Page 1 PLANET ECLIPSE: GTEK M170R USER MANUAL / ENGLISH GTEK M170R...
  • Page 2 WARNINGS READ CAREFULLY BEFORE USE READ CAREFULLY BEFORE USE THE PLANET ECLIPSE M170R IS NOT A TOY. PAINTBALL Always fit a barrel blocking device to the M170R when not Persons under 18 years of age must have adult supervision when This Users Manual is in English.
  • Page 3: Table Of Contents

    Online maintenance videos SUPPORT (28-35) FAULT FINDING (16 -17) Index Our promise Notes Fault finding tables Warranty card Notes FOLLOW OUR OFFICIAL PLANET ECLIPSE SOCIAL MEDIA CHANNELS TO KEEP UP TO DATE GTEK M170R GTEK M170R WITH OUR TECH SUPPORT EVENTS CALENDAR.
  • Page 4: Quick Start

    Do not install a compressed air system or load paintballs into the M170R until The marker will now fire when the trigger is pulled. you feel confident with your ability to handle the marker safely and responsibly. GTEK M170R GTEK M170R...
  • Page 5: Push Button Safety

    Ensure that the M170R is set to PUSH SAFE and a barrel blocking device is Ensure that a barrel blocking device is attached when the marker is set to safe. attached until you are ready to use the marker. GTEK M170R GTEK M170R...
  • Page 6: Velocity Adjustment

    If the marker can be fired while the switch is set to safe, the activation-point screw needs adjusting. Turn the screw counter-clockwise to delay the activation point in the trigger pull NEVER point your marker in the direction of other people when not on the field. until the marker does not fire with set to safe. GTEK M170R GTEK M170R...
  • Page 7: Unloading The M170R

    NEVER leave the M170R gassed up when unloading. NEVER point your marker in the direction of other people when not on the field. Remove any paintballs from the breech before storing your M170R. GTEK M170R GTEK M170R...
  • Page 8: Storage And Transportation

    Remove the barrel from the marker. Observe and obey all local and national laws concerning the Head over to our official Planet Eclipse YouTube channel and check Make sure the marker is clean of any paint residue, dirt transportation of paintball markers.
  • Page 9: Fault Finding

    The safety button is blocked or damaged. Clean and inspect the safety button assembly. If an issue with the M170R cannot be solved using the fault finding guide, contact your nearest Eclipse Service Centre for assistance. GTEK M170R GTEK M170R...
  • Page 10: Parts List

    FIG-1 FIG-1 Clamping feed tube assembly Front frame screw Marker body Frame assembly Quick-release bonnet Trigger assembly Bolt assembly SL6 inline regulator assembly Rubber detent Foregrip Three-way assembly POPS assembly Rear frame screw Push button safety GTEK M170R GTEK M170R...
  • Page 11: Removing Grips

    Always make sure the marker is off with a barrel blocking device installed and that no paintballs are in the M170R or loader. Compressed air and nitrogen systems can be extremely dangerous if handled or used incorrectly. GTEK M170R GTEK M170R...
  • Page 12: Sl6 Inline Regulator

    Reset the SL6 regulator to factory after re-assembly. Only use the M170R SL6 spring with the SL6 inline regulator. Purge poppet spring Failure to re-install the purge poppet assembly correctly could Plunger seriously damage the M170R. Bolt pin GTEK M170R GTEK M170R...
  • Page 13: Three-Way Assembly

    Three-way valve cap POPS pin POPS bonnet POPS insert Three-way valve gasket Three-way valve body POPS body 4 x 1 NBR70 Push rod Latch spring #6 Seal (custom) #004 NBR70 Three-way valve gasket #6 Seal (custom) POPS button GTEK M170R GTEK M170R...
  • Page 14: Trigger Assembly

    Feed tube Bearing retainer screw Short clamping feed screw Bearing carrier screws 6-32 UNC x 1/8 10-32 UNF x 1/2” M2.5 x 5 cap head socket screws socket set screw GTEK M170R GTEK M170R...
  • Page 15: Support

    Push safe: 07,08,09,13,17 Eclipse service centre: 08,09,17 Eclipse Tech Hub: 15 Warnings: 02,03,31 Quick-release bonnet: 19,23 Warranty: 29,31,32 For more information about our Planet Eclipse Approved Tech Centres, visit our Reg body: 22 servicing page online: Regulator: 02,03,04,07,16,17,19,22 PLANETECLIPSE.COM/SITE/SERVICE-CENTRES Regulator piston: 22...
  • Page 16: Notes

    12 months from the time of original purchase**. I verify that I am least 18 years of age and I have read Warranty cover is dependent on successful completion, and receipt by Planet Eclipse Limited, of warranty registration and proof the manual supplied with my Eclipse paintball marker ®...
  • Page 17 NOTES GET MORE - PLANETECLIPSE.COM STICK. SEND. PLANET ECLIPSE 130 FRANKLIN STREET BUILDING L4 & L5 WARREN RHODE ISLAND 02885 U.S.A. TO BENEFIT FROM OUR INDUSTRY-LEADING GLOBAL TECH SUPPORT PLEASE REGISTER YOUR MARKER ONLINE TODAY WARRANTY.PLANETECLIPSE.COM GTEK M170R GTEK M170R...
  • Page 18 SUPPORT SUPPORT NOTES NOTES GTEK M170R GTEK M170R...
  • Page 19 Additional U.S. and International Patents may be pending. EUROPE 130 Franklin Street Unit 14 Premier Park, Acheson Way © Planet Eclipse Ltd. Pe-Paintball.De Gmbh Building L4 & L5 Trafford Park Road, Trafford Park Langenberger Str. 9 Tor 5 & 6...

Table of Contents