PLANET ECLIPSE EGO TEN Operator's Manual page 16

sWitcHinG on tHe eGo10
To switch on the Ego10 press the
succession, referred to elsewhere in this manual as 'double-
clicking' . The Ego10 can also be switched on by pushing
and holding the
sWitcHinG off tHe
eGo10
Press and hold the
release the
off.
Ego10. Alternatively double click the
menu tree then press
note: ThE DOUblE CliCKiNg FEATUrE iS USEr
SElECTAblE, FACTOry DEFAUlT iS SET TO ON. iT CAN bE
TUrNED OFF USiNg ThE DOUblE CliCK PArAMETEr iN
firinG tHe eGo10
Pull the trigger to fire the Ego10. The entire firing sequence
is controlled electronically by the Ego10 circuit board,
enabling any user to easily achieve high rates of fire.
tHe eGo10 circuit
board
There are three sockets on the Ego10 circuit board two
of which are occupied by the bbSS connector (A) and
the Ego10 solenoid connector (b). The third socket on
the board (C) is the auxiliary socket to which third party
products such as loaders and rF transmitters can be
connected using the relevant wiring harness
3.2).
note: ThE AUxiliAry SOCKET iS TUrNED ON AND
OFF MANUAlly viA ThE AUx OUT PArAMETEr iN ThE
16.
button twice in quick
button
(fiGure 3.1).
button until the display shows
button and re-press it to turn off the
button to enter the
to turn off the Ego10.
ThE hArDwArE MENU (SEE PAgE 44)
hArDwArE MENU ON PAgE 44
turn
(see fiGure
fiG 3.1
b
a
c
fiG 3.2