What's Included; Explanation Of Symbols; Safety; Intended Use - ProCharger 10020103 Instructions For Use Manual

5. When the LED next to the "Battery full"
charging is complete and the battery can be disconnected in the sequence
described below.
6. Disconnect the power plug from the socket.
7. Disconnect the charging clamps from the battery (or the black charging clamp
from the vehicle chassis or engine block if the battery is in the vehicle) or
disconnect the charging cable with the ring terminals from the charger using
the quick connector.

3 | What's included

1
1 ProCharger 10.000 charger
2 Charging clamp cable
30
symbol lights up, this means that
2
3
3 Ring terminal cable
4 Instructions (not shown)
4 | Explanations of symbols
The following symbols and signal words are used in these Instructions for Use, on
the ProCharger 10.000 or on the packaging.
This symbol/signal word indicates a hazard with
a medium risk level which, if not avoided, may
WARNING!
result in death or serious injury.
This symbol/signal word indicates a hazard with
CAUTION!
a low risk level which, if not avoided, may result in
minor or moderate injury.
This signal word warns of possible material
IMPORTANT!
damage.
This symbol gives you useful additional
information about assembly or usage.
Declaration of Conformity (see section
"Declaration of Conformity"): Products marked
with this symbol comply with all applicable
community regulations of the European Economic
Area.
This symbol indicates electrical devices which
have double protective insulation.
Devices marked with this symbol may only be
operated indoors.
This symbol indicates how the packaging and
product itself may be recycled.
Old electrical devices must not be disposed of
along with domestic waste.

5 | Safety

5.1 | Intended use

This charger is designed exclusively for charging lead-acid, gel, AGM, calcium
and pure-lead vehicle batteries with a nominal voltage of 6 V or 12 V. The
31