Advertisement
Available languages
Available languages
Translation of original instructions for use
Contents
1
| Product description
2
| Quick-start guide
3
4
5
6
7
8
9
10 | Charging batteries on motorcycles
with CAN-bus system
28
PROCHARGER 10.000 BATTERY CHARGER,
DIAGNOSTIC AND MAINTENANCE DEVICE
29
1 | Product description
29
30
The ProCharger 10.000 is an advanced and intelligent battery charging, diagnosis
31
and test device for all 6 V and 12 V lead-acid, gel, AGM, calcium, pure lead and
lithium-ion vehicle batteries. State-of-the-art characteristic-controlled charging
31
technology, in conjunction with an intelligent software controller, ensures optimum
31
charging and maintenance for your battery at all times. Vehicles with a CAN bus
32
system can also be conveniently charged with the optional ProCharger charger
32
plug, via the existing vehicle socket. 19 LED indicators keep you informed as
35
to the current operating status. The ProCharger 10.000 is protected against
overload, reverse polarity and short-circuit, and connecting it up is spark-free.
37
These Instructions for Use apply exclusively for the ProCharger 10.000 charger.
37
They contain important information on safety and handling. Read these
39
Instructions for Use carefully, in particular the safety instructions, before using
40
the ProCharger 10.000 charger. Failure to follow these instructions may lead to
41
serious injury or damage. Keep the Instructions for Use for future reference. If
you pass the ProCharger 10.000 on to a third party, you must also hand over
41
these Instructions for Use. The Instructions for Use are based on the standards
42
and regulations applicable in the European Union and refl ect the current state of
43
technology. If abroad, observe country-specifi c guidelines and laws.
44
45
2 | Quick-start guide
45
45
Beforehand, read the safety instructions and the section "Preparation, connection
and operation".
46
1. Connect one of the charging cables (with charging clamps or ring terminals) to
46
the charger using the quick connector.
47
2. Connect the charging clamps or ring terminals to the battery with the correct
47
polarity (if the battery is in the vehicle, connect the black clamp (negative) to
48
the vehicle chassis or the engine block).
3. Connect the power plug to the power socket. The
3. Connect the power plug to the power socket. The
48
charger detects the connected battery the
49
4. Press the relevant buttons (charging current, voltage, battery type) to select a
49
charging current with the "MODE button" from 1.5 to 10 A, battery voltage "6 V
49
or 12 V" and battery type "TYPE" (standard lead battery, Li-ion, winter/AGM
49
mode or CAN bus). Once you have selected the battery type, charging begins
automatically and the relevant LEDs light up.
50
Charging will only begin if you have selected a suitable battery type with
50
the "TYPE" button.
51
LED lights up. If the
LED indicator will light up.
29
Advertisement
Chapters
