Connecting The Speed Sensor Harness - Toro Multi Pro 41240 Operator's Manual

Figure 15
1. Slot (battery base)
2. Cover (positive battery
terminal)
2. Slide the cover back and remove the negative
battery terminal from the battery
3. Remove the positive battery terminal from the
battery (Figure 15).
7
Connecting the Speed
Sensor Harness
No Parts Required
Connecting the Speed Sensor
Harness (HD-Series Models with a
Manual Transmission)
1. At the wire harness for the sprayer, locate the
3-socket connector for the speed sensor circuit
and the 3-pin connector for the vehicle circuit.
2. At the transaxle of the machine, connect the
3-pin connector of the wire harness of the
machine for speed sensor into the 3-socket
connector of the sprayer harness for the speed
sensor (Figure 16).
g028456
3. Tab (battery cover)
4. Terminal (negative battery
cable)
(Figure 15).
1. Existing speed sensor plugs
3. Connect the 3-pin connector for the vehicle
circuit of the wire harness of the sprayer into the
3-pin socket for the vehicle circuit of the wire
harness for the machine.
Connecting the Speed Sensor
Harness (HDX-Auto Model)
1. At the wire harness for the sprayer, locate the
3-socket connector for the speed sensor circuit
(Figure 17).
1. 3-pin connector (machine
wire harness—speed
sensor)
2. 3-socket connector
(sprayer wire
harness—speed sensor)
3. Hydraulic tank
17
Figure 16
Figure 17
4. Rear frame tube
5. Back of the machine
6. Right side of the machine
g024088
g028436