Connecting The Speed Sensor Harness - Toro Multi Pro WM 41240 Operator's Manual

bed pivot tube at the end of the vehicle frame
(Figure 13).
1. Tapered clevis pin
7. Install a tapered clevis pin and 2 lynch pins to
the pivot lug to secure the tank assembly to the
frame (Figure 13).
8. Extend the lift cylinders to raise the tank and
support its weight.
Note:
Disconnect the tank assembly from the
lifting equipment.
9. Remove the bed support from the storage
brackets on back of the ROPS panel
1. Bed support
10. Push the bed support onto the cylinder rod,
making sure that the support end tabs rest on
the end of cylinder barrel and on the cylinder rod
end (Figure 15).
Figure 13
2. Lynch pin
(Figure
Figure 14
g022354
1. Bed support
2. Lift cylinder
6
Connecting the Speed
Sensor Harness
14).
No Parts Required
Connecting the Speed Sensor
Harness (HD-Series Models with a
Manual Transmission)
1. At the wiring harness for the sprayer, locate the
3-socket connector for the speed sensor circuit
and the 3-pin connector for the vehicle circuit.
2. At the transaxle of the machine, connect the
3-pin connector of the wiring harness of the
g002397
machine for speed sensor into the 3-socket
connector of the sprayer harness for the speed
sensor (Figure
20
Figure 15
3. Skid frame
16).
g009164