Table of Contents
Advertisement
1. Section-hinge spring
2. Jam nut
4.
Repeat the procedure for each spring on both
section hinges.
5.
Move the sections into the transport 'X' position.
See
Changing the Spray Section Position (page
41)
for more information.
3
Checking the Outer Boom
Cradles
No Parts Required
Procedure
1.
Engage the parking brake, start the engine, and
set the throttle to idle.
2.
Slowly raise the left or right outer boom until it
first contacts the upper cradle tube.
3.
Slowly raise the other outer boom until it first
contacts the cradle.
4.
Look at the area on the upper cradle tubes
where the slide blocks on the top tube of the
outer boom contact the cradles.
Figure 5
3. Compressed spring
dimension—4 cm (1-1/2
inches)
Note:
The cradle is adjusted correctly when
the blocks contact the cradle at the bend in the
upper cradle tube
g035648
5.
If either upper cradle tube is misaligned with
the slide block as shown in
or
Figure
Aligning the Cradles to the Outer Booms (page
80).
The upper cradle tube is aligned behind slide block.
1. Slide block
14
(Figure
6).
Figure 6
Figure
9, adjust the cradle position; refer to
Figure 7
2. Upper cradle tube
g354255
7,
Figure
8,
g354256
Advertisement
Table of Contents
