Table of Contents
Advertisement
SLM-3650 Satellite Modem
Options
Refer to Figure A-17 for the Reed-Solomon code page format. The outer Codec reads the
data in blocks of n bytes and recalculates the check bytes that were appended by the
encoder. If the recalculated data bytes do not match the check bytes received, the Codec
makes the necessary corrections to the data within the data block. The letter n represents
the total number of bytes in a given block of data out of the Codec. The letter k represents
the number of data bytes in a given block.
The term n - k = 2t is the total number of check bytes appended to the end of the data.
The terms k, n, and t will vary depending on the Reed-Solomon coding used. The Codec
then sends the corrected data to a FIFO.
Because the check bytes are not part of the real data, a synchronous FIFO is used to
buffer the data and strip the check bytes out of the blocks of data. The data then passes
through a parallel converter to be serialized.
The data is sent through a self-synchronizing serial descrambler in accordance with the
INTELSAT-308 Rev. 6B specification. The descrambler converts the data back into the
original data that the user intended to send. The synchronous descrambler is synchronized
by the detection of the unique word at the end of each Reed-Solomon page. The data is
then sent to the interface PCB for further processing.
A.2.3.1
Reed-Solomon Specifications (Optional)
Refer to Table A-21 for Reed-Solomon optional specifications.
Table A-21. Reed-Solomon Specifications Optional
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Overhead Type
IDR (T1)
1640 kbps
IDR (E1)
2144 kbps
D&I
64 to 1920 kbps
IBS
64 to 2048 kbps
ASYNC
2.4 to 2048 kbps
No Overhead
2.4 to 4.555 kbps
AUPC
2.4 to 2048 kbps
A–67
Data Rate
Revision 3
MN/SLM3650.IOM
Advertisement
Table of Contents
