Table of Contents
Advertisement
SLM-3650 Satellite Modem
Installation
2.2
Installation
The modem arrives fully assembled from the factory. After unpacking the modem, install
the modem as follows:
1. If required, install the mounting bracket in equipment rack (Figure 2-1). Install
and tighten the bracket bolts.
2. Loosen the screw with flat washer located on the left side of modem chassis.
Mount the modem chassis into the equipment rack and slide the screw with flat
washer through the slot of the mounting bracket. Tighten the screw sufficiently to
allow the modem chassis to slide in the bracket.
3. Connect the cables to the proper locations on the rear panel. Refer to Section 2.3
for connector pinouts, placement, and function.
4. Connect the primary power cable to the power source. Before turning on the
power switch, become familiar with the front panel operation in Chapter 3.
5. If problems exist with the installation, refer to Chapter 5 for troubleshooting
information.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2-2
Revision 3
MN/SLM3650.IOM
Advertisement
Table of Contents
