Table of Contents
Advertisement
SLM-3650 Satellite Modem
Options
A.1.2.3
Entering Access Codes from the Front Panel
Step
1
2
3
4
5
6
7
8
9
10
11
A.1.2.4
Entering Access Codes from the Remote Control Port
Step
1
2
3
Main Board:
Overhead board:
Mux/Demux Board:
TX-Reed-Solomon:
RX-Reed-Solomon:
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Procedure
Press CLEAR to return to Main menu.
Use the [←] [→] keys to go to the Function Select: Utility menu.
Press <ENTER>.
Go to Utility: Modem Type menu.
Press <ENTER>.
Go to Configuration Code-Modem menu.
Press <ENTER>.
Menu should display as follows:
1) AAAAAAAAAA
2) AAAAAAAAAA
To enter the code, press <ENTER> and use the [↑] [↓] keys to select an alpha numeric character.
Use [→] to move to the next character or to move to the next line. Repeat this procedure until all 20
characters of the code have been entered.
After completing entry of the 20-character code, press <ENTER>. The unit should display Modem
Initialization and will reboot to the factory default settings with the new option available.
If a wrong or invalid code is entered, the unit will display Wrong Code Entered! and no changes will
occur. Retry the code, verify that the code is correct, or request assistance from Comtech EF Data
Customer Support.
Procedure
Establish remote communication with the unit. Display will show REMOTE MODE
(if applicable).
Enter the following commands as needed to enable the option related to each board:
The modem should re-initialize and boot up to the factory default settings.
Note: If the unit is an SDR-54/54A, the power should be cycled to re-initialize the unit and enable the
option(s).
<x/CCMD_code
<x/CCOD_code
x = address
<x/CCMX_code
code = 20 digit configuration code
<x/CCTR_code
<x/CCRR_code
A–5
Revision 3
MN/SLM3650.IOM
Advertisement
Table of Contents
