Comtech EF Data SLM-3650 Installation And Operation Manual page 145

Satellite modem
Table of Contents

Advertisement

SLM-3650 Satellite Modem
Operation
SELF TEST
M&C FIRMWARE
BOOT FIRMWARE
FPGA FIRMWARE
TURBO FIRMWARE
DISPLAY CONTRAST
EXT AGC: MIN PWR
EXT AGC: MAX PWR
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Select OFF, AUTO, or RUN. After completion of the test, SELF TEST ("PASSED" or
"FAILED") is displayed.
OFF bypasses built-in self test.
AUTO initiates built-in self test when turning on modem.
RUN initializes self test.
Displays the M&C module firmware version.
Press [ENTER] to display the month, day, and year.
Displays the BOOT module firmware version.
Press [ENTER] to display the month, day, and year.
Press [ENTER] again, to display version number.
Displays the FPGA module firmware version.
Press [ENTER] to display the month, day, and year.
Displays the Turbo module firmware version.
Press [ENTER] to display the month, day, and year.
Conditional: Only if Turbo card is installed.
Sets the contrast setting of the Front Panel menu.
Press [ENTER] to begin. Press [↑] or [↓] to increment or decrement the number at the
flashing cursor, from 0 to 100. Press [ENTER] to execute the change.
Sets the AGC voltage for a RX signal level of -25.0 dBm. The voltage range is 0.0 to 10.0V,
in 0.5V steps.
Upon entry, the current external AGC voltage level is displayed. Press [↑] or [↓] to
increment or decrement the AGC voltage level in 0.5V steps. Press [ENTER] to execute the
change.
Note: For any receive signal level between -25.0 and -60.0 dBm, the software will
interpolate the required AGC voltage.
Sets the AGC voltage for a RX signal level of -60.0 dBm. The voltage range is 0.0 to 10.0V,
in 0.5V steps.
Upon entry, the current external AGC voltage level is displayed. Press [↑] or [↓] to
increment or decrement the AGC voltage level in 0.5V steps. Press [ENTER] to execute the
change.
Note: For any receive signal level between -25.0 and -60.0 dBm, the software will
interpolate the required AGC voltage.
3–65
Revision 3
MN/SLM3650.IOM

Advertisement

Table of Contents
loading

Table of Contents