Changing The Display; Auto Display; Manual Display; Date Display - Toho Electronics TRM-10C Instruction Manual

6.5 Changing the Display

Display selection procedure
①Press the "MENU" key to indicate "
②Use the "PRINT" key to select a required display screen from the menu below. Press the "ENT" key.
③" □" is indicated in case of manual display. Use the "PRINT" key to select the channel number.
Press the "ENT" key.
" "(AUTO)
" "(MAN)
" "(DATE)
" "(TIME)
" "(OFF)

6.5.1 Auto Display

Indicates the process variable of each channel sequentially at intervals of 2.4 seconds.
(Data renewal period 120ms.)
Channel Number (1-digit)
H : Upper-limit Alarm
L : Lower-limit Alarm

6.5.2 Manual Display

Indicates the Process variable of specific channel, it updates every measurement cycle(120ms).
The data is the same as Auto display.
Pressing the "ENT" key changes the indicated channel number (it increments).

6.5.3 Date Display

Indicates the month and day. Leap year adjustment is automatic.

6.5.4 Time Display

Indicates hour and minute.

6.5.5 Display Off

Turns off the process variable display. Key operation is the same as usual. To switch to other display,
take steps ① through ③ mentioned above.
：Auto display
：Manual display
：Date display
：Time display
：Display off
Ｈ
Example of October 18
Month Day
Example of 12:15
Hour Minute
―50―
" , and press the "ENT" key.
Process Variable (5-digt)
HXPRM10mnCT002E