Reversing Sensor System - Mitsubishi ASX Manual

l [Except vehicles equipped with keyless oper-
ation system]
Turn the ignition switch to the "LOCK" or
"ACC" position.
Put the operation mode in OFF or ACC.
l "CRUISE" indication lamp is turned OFF.

Reversing sensor system*

E00615500215
This system operates when you are backing the ve-
hicle. It uses corner and back sensors to detect an
obstacle and sounds a buzzer to inform you of the
approximate distance to the obstacle.
CAUTION
l The reversing sensor system assists you in
determining the approximate distance be-
tween the vehicle and an obstacle located
behind the vehicle. It has limitations in
terms of detectable areas and objects,
and may not properly detect some ob-
jects. Therefore, do not place excessive
confidence in the reversing sensor system
and operate the vehicle as carefully as
you would do with a vehicle not equipped
with this system.
l Make sure to check the surroundings
with your own eyes to ensure safety. Do
not operate the vehicle by relying on the
reversing sensor system alone.
Obstacle detection areas
E00615600346
The detection areas of the corner and back sensors
are limited to those shown in the illustration. More-
over, the sensors are unable to detect low or thin ob-
jects or objects near the rear bumper. Thus, make
sure to check the surroundings as you operate the
vehicle in a safe manner.
Starting and driving
Corner and back sensor locations
There are two corner sensors (A) at the corners of
the rear bumper, and two back sensors (B) in the
centre of the rear bumper.
Reversing sensor system detection areas
Depending on whether the vehicle is equipped with
a towing bar, you can change the reversing sensor
system between the standard mode and the towing
bar mode. The towing bar mode changes the sys-
tem to exclude the area in which the towing bar is
mounted from the detection areas.
4
4-47