Reversing Sensor System - Mitsubishi Outlander PHEV 2019 Manual

3. Hold down the multi-information dis-
play switch for about 3 seconds or more.
The setting changes the selected tyre ID
set.
4. The valid tyre ID set is changed, and the
number of the tyre pressure monitoring
system (TPMS) SET indicator
changed.
NOTE
l Each time this procedure is done, the tyre ID
set is changed. (1 - 2 - 1 - 2 ...)
l The tyre ID set is NOT changed, in case that
only 1 set of ID is registered.
NOTE
l When changing the tyre ID set, the reset
function of low tyre pressure warning
threshold is automatically started. (The
warning lamp starts flashing slowly.) If the
tyre is warm at this time, the reset function
should be executed again when the tyre is
cold.

Reversing sensor system*

This system operates when you are backing
the vehicle. It uses corner and back sensors to
detect an obstacle and the information screen
in the multi information display and the buz-
zer to inform you of the approximate distance
to the obstacle.
is
CAUTION
l The reversing sensor system assists you in
determining the approximate distance be-
tween the vehicle and an obstacle located
behind the vehicle. It has limitations in terms
of detectable areas and objects, and may not
properly detect some objects. Therefore, do
not place excessive confidence in the revers-
ing sensor system and operate the vehicle as
carefully as you would do with a vehicle not
equipped with this system.
OGGE19E1
Reversing sensor system*
CAUTION
l Make sure to check the surroundings with
your own eyes to ensure safety. Do not oper-
ate the vehicle by relying on the reversing
sensor system alone.
Obstacle detection areas
The detection areas of the corner and back
sensors are limited to those shown in the il-
lustration. Moreover, the sensors are unable
E00615501515
to detect low or thin objects or objects near
the rear bumper. Thus, make sure to check
the surroundings as you operate the vehicle in
a safe manner.
Starting and driving
E00615601718
7
7-97