Configuring The Snmp Subagent In The Avaya Ethernet Switch (If Used); Default Ip Addresses For The Ethernet Switch - Avaya S8700 Series Installing And Configuring

Hide thumbs Also See for S8700 Series:

Maintenance manual (2618 pages)

Installing manual (342 pages)

Installing (326 pages)

Table Of Contents

Table of Contents

For the menus and commands to set these traps, see the user guide that comes with the SNMP

module.

Configuring the SNMP subagent in the Avaya Ethernet

switch (if used)

Important:

These procedures apply only to a new, Avaya-supplied uninterruptible power

Important:

supply (UPS) with a Simple Network Management Protocol (SNMP) module. Do

not use these procedures to set traps on a UPS that Avaya does not supply.

You must administer the Simple Network Management Protocol (SNMP) subagent in the Avaya

Ethernet switch to report alarms to the media server when problems occur.

For the SNMP module to properly report alarms, you must configure a unique IP address for the

UPS on both the SNMP module and the media server. This IP address can be a

customer-provided address or the Avaya-provided default address. At a minimum, you must

configure the following items:

The IP address

●

The subnet mask

●

The gateway IP address

●

The trap receiver IP address

●

The community string (get, set, trap)

●

The brand, the model, or the firmware load of the Ethernet switch that Avaya supplies can

change without notice. For this reason, this document does not provide specific instructions on

how to connect to and configure the SNMP subagent. For more information, see the

documentation that comes with the Ethernet switch. Also see the Basic Configuration section of

the Quick Start Guide and the documentation CD-ROM that comes with the Ethernet switch for

the default user ID, password, and configuration commands.

Note:

For the Ethernet switch to report alarms properly, you must also configure the IP

Note:

addresses for the Ethernet switches in the media servers.

Default IP addresses for the Ethernet switch

For how to administer the SNMP subagent in the Ethernet switches see

Ethernet switch

both Ethernet switches.

Installing and Configuring the Avaya S8700-Series Media Server