Controller Firmware
Revision
General Precautions
This revision on the DriveLogix 5730 User Manual corresponds to the
following:
• version 13 and later controller firmware
• version 13 and later RSLogix 5000 programming software
• version 3.02 and later DriveExecutive programming software
Class 1 LED Product
ATTENTION: Hazard of permanent eye damage exists when
!
using optical transmission equipment. This product emits intense
light and invisible radiation. Do not look into module ports or
fiber optic cable connectors.
ATTENTION: This drive contains ESD (Electrostatic
!
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
"Guarding Against Electrostatic Damage" or any other applicable
ESD protection handbook.
ATTENTION: Only qualified personnel familiar with the
!
PowerFlex 700S Drive and associated machinery should plan or
implement the installation, start-up and subsequent maintenance
of the system. Failure to comply may result in personal injury
and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, verify that the
!
voltage on the bus capacitors has discharged before performing
any work on the drive. Measure the DC bus voltage at the +DC &
–DC terminals of the Power Terminal Block. The voltage must be
zero.
p-3
Need help?
Do you have a question about the Allen-Bradley DriveLogix 5730 and is the answer not in the manual?