Trouble Shooting; Non-Operation Problems - MUTOH ValueCut II VC2-600 User Manual

ValueCut USER MANUAL

7 Trouble Shooting

This chapter is to help you correct some common problems you may come across. Prior to getting into
the details of this chapter, please be sure that your application environment is compatible with the cutting
plotter.
Note:
Before having your cutting plotter serviced, please make sure that the malfunction is in your cutting
plotter, not the result of an interface problem or a malfunction in your computer or a software problem.
Possible Causes:

7.1 Non-operation Problems

Check the following first:

Does the AC power cord plug in properly?

Does the AC power cord connected to the power connector properly?

Does the power LED still illuminate?
Solutions:
If the LCM is able to display the message, the cutting plotter should be in a normal
condition. Switch off the cutting plotter and turn it on again to see if the problem still
existing.
If the LCM is not able to display any message, contact the technician from your dealer.
VC2E-A-00
Why is the cutting plotter not functioning?
69
Trouble Shooting