Aas Ii On Valuecut - MUTOH ValueCut II VC2-600 User Manual

ValueCut USER MANUAL

Margin: The distance between marks and images
 Range: 1 mm ~ 50 mm
 Optimized Setting: 5 mm
The cutter cannot detect the marks while:

Cutter carriage is not located near the outside area of first mark before detecting (See the
picture in page 5-7 for auto-detecting area of first mark.)

Medium thickness is more than 0.8 mm

Transparent medium is used

Non-monochrome drawing. The marks can't be read if is printed on colored medium

Dirty or creased medium surface

5.2.3 AAS II on ValueCut

There are three types of AAS II mark patterns: 4-Point Positioning, Segmental Positioning, and
Segmental cutting. Note that before print out your designs by inkjet printers, the registration marks have
to be created on your graphic designs by cutting software. Hand-made marks or drawings won't be
reorganized by Mutoh cutting plotters.
1. 4-Point Positioning
This is the basic mark pattern that AAS II will auto detect four registration marks and contour cut
images inside those marks.

Command: Esc.D1;(XDist);(YDist):

Layout: 4 registration marks at the 4 corners around the design
VC2E-A-00
57
Automatic Aligning System