Automatic Aligning System
Note:
Before adjusting the AAS II settings, please proceed scaling for width and length.
The blade offset value isn't set for this test graphic, please set it according to the blade you
use.
If you have any question, please contact us or your local distributor for assistance.
5.4 Registration Mark Offset Range
Please correctly load your media (refer to the alignment ruler on the platen) to make sure the registration
marks are successfully detected. Deviation exceeds the range below will lead to detection failure.
X : - Value
Y : + Value
62
ValueCut USER MANUAL
X : + Valu
Y : + Valu
VC2E-A-00