FlexiSTARTER Quick Start Guide
8.10.3 Cut Contour
The basic setup is the same as the Cut/Plot window.
The ValueCut executes to cut the contour in the following process.
1
2
3
4
5
1.
Click on
media size attached to the ValueCut.
2.
Select "Send now" in the Send mode
blank.
3.
Place the check mark in the Weed
border.
4.
Click on
window select "Cut First". Click on
to close the window.
5.
Click on
ValueCut cutting data. Then, the cutting
job may start.
98
ValueCut USER MANUAL
to detect and present
, then in the opened
to send the
VC2E-A-00