MUTOH ValueCut II VC2-600 User Manual page 65

ValueCut USER MANUAL
Step 2
Print the Graphics

Print the graphic and the marks with your printer.
Important:
Print the graphic at 100% scale (actual size).
Do not change the scale to print your graphic.

When printing on a roll media, make sure the orientation as following:
Step 3

The Origin Mark is different from the rest registration marks. Please make sure the media is
fed with correct direction.

Use the JOG key to move the cursor, and then adjust the location of the cutter holder to the
inside corner of the origin mark.

Switch to online mode from the control panel.
Step 4
Cut the Contour

Send out the command from software to perform the contour cutting job.
VC2E-A-00
65
Automatic Aligning System
or
The cutter holder should
be located the inside of
the corner.