MUTOH ValueCut II VC2-600 User Manual page 100

FlexiSTARTER Quick Start Guide ValueCut USER MANUAL
Once the 4 point (2 point) adjustment is done, below message will show up and then change the holder
to cutter holder. Press "OK" key and will start plotting.
Procedure of "Digitize alignment (Bomb sight)"
Adjust the position from the Plotter side JOG key.
Below message will show up to the Flexi once plotting starts and at the same time plotter side display will
change to below.
Move the pen head (pen tip) to registration mark#1 from the plotter side JOG key.
Press "ENTER" key at the point the registration mark and pen head (pen tip) overlaps.
And then press the Flexi "OK" key. Follow the same steps for registration mark #2, #3......
Once the 4 point (2 point) adjustment is done, below message will show up and then change the holder
to cutter holder. Press "OK" key and will start plotting.
Note: Digitize alignment (Bomb sight) => correspond to Main Firmware Ver. 3.00 or above.
100
VC2E-A-00