MUTOH ValueCut II VC2-600 User Manual page 25

ValueCut USER MANUAL Installation
Step 3
Position the Desktop Support Brackets beside the Roll Holder Support and insert M6 screws into the Roll
Holder Support and tighten them with 5 mm L-shape screw driver. (Refer to Figure 2-14 at the left)
Step 4
Put the bottom of machine in lateral, and position the Roll Holder Assembly beside the bottom of the
machine. Then, insert the M6 screws into the holes of Roll Holder support assembly and tighten them
with 5 mm L-shape screwdriver. Like Figure 2-15.
M6 screws
Screw holes
Figure 2-15
Roll Holder Assembly
Figure 2-16
Roll Holders
Step 5
Place the two roll holders into the holes of Roll Holder Support (Figure 2-16). To install the roll holder with
damper, please refer to chapter 2.2, step 8 to step 10.
Step 6
The complete Desktop Media Support System will be shown as in Figure 2-17.
Figure 2-17
25
VC2E-A-00