MUTOH ValueCut II VC2-600 User Manual page 50

Operation
Figure 4-10
Step 4
Turn the roll downward to make an equal tension across the media. (Figure 4-11)
Step 5
Move the pinch rollers to the appraise location and note that the pinch rollers must be positioned above
the grid drums.
Note:
Make sure that the media tension is equally distributed from left to right. If the media were not
tightened enough against the platen, it would cause tracking problems!
Step 6
Push the lever backward to lower down the pinch rollers.
Step 7
Fix roll media guide bushes on the roll holder to secure the roll media.
Step 8
The media sizing selection menu (Roll, Edge, Single) appears on the control panel. Use ~ or | key to
choose Roll.
Step 9
Use the reverse steps to remove the media.
Figure 4-11
50
ValueCut USER MANUAL
VC2E-A-00