Troubleshooting; Can Not Send The Data From Flexistarter - MUTOH ValueCut II VC2-600 User Manual

ValueCut USER MANUAL

8.12 Troubleshooting

8.12.1 Can not send the data from FlexiSTARTER

Confirm the port setting of FlexiSTARTER.
When you turn on the plotter after the FlexiSTARTER, you may not be able to send data to the plotter.
Follow the procedures below to set the output port to "USB_Printer_0" again.
Open the Production Manager. Right click on "Mutoh ValueCut VC2-1300@xxxx" appeared on the
left pane of the window (in the example below, Mutoh ValueCut VC2-1300@USB_Printer_0
appears), then choose Change Port.
The Change Port dialog appears.
VC2E-A-00
FlexiSTARTER Quick Start Guide
103