MUTOH ValueCut II VC2-600 User Manual page 42

Control Panel
1. To switch between online mode and offline mode.
2. To stop the cutting job or abort the change of setting.
To set or modify the distance between the blade tip and the
center axis.
Please refer to section 4.3 or Chapter A-2 for more
information.
To set or modify the value of tool force.
When the cutting force exceeds 450g, the maximum cutting
speed would be 15cm/sec and the cutting quality would be
Small Letter Mode (0.2g) and while the cutting force is
300g-449g, the maximum cutting speed would be 30 cm/sec
and the cutting quality would be Fine Mode (0.5g)
Speed To set or modify tool down speed at horizontal moving.
AAS Speed To set or modify AAS detecting speed.
Up Accel. To set or modify tool acceleration levels while the tool move
from endpoint to next start point at horizontal moving.
Up Speed To set or modify tool up speed at horizontal moving.
Quality To set or modify cutting quality.
While cutting small letter, set as "Small letter".
While cutting in high speed, set as "Draft".
For normal operation, set as "Normal".
Square Cut To perform a cutting test at present blade position.
For more information, please refer to "4.3 Adjusting the
Cutting Force and Offset" to adjust blade force and cutting
speed.
Repeat AAS To repeat AAS jobs automatically without having to operate
Job on the computer side.
Please be noted that this feature is mainly applied to the
Single paper mode; please ensure a new piece of material
you wish to apply this feature on is loaded and the origin
repositioned to the first registration mark before starting.
When the first AAS job repeat completes, the user will be
offered the choice of "Repeat AAS Job Again", please
press "Online/Offline" to return to the main menu.
This option will appear after finishing reading all registration
marks.
Once press this key, the cutting job will be terminated
immediately and cannot be resumed.
[ ONLINE/OFFLINE ]
[ OFFSET ]
[ FORCE ]
[ SPEED ]
[ CUT TEST ]
42
ValueCut USER MANUAL
0.000~1.000 mm 0.250 mm
5~600 gram; 80 gram
5 gram / step
3~153 cm / sec; 72 cm / sec
3cm/sec per step
Medium, Low Medium
High, Medium, Medium
Low
3~153 cm / sec; 72 cm / sec
3 cm / sec per
step
Draft (4.2G), Fair Normal
(2.8G), Normal
(1.4G), Fine
(0.7G), Small
Letter (0.2G)
VC2E-A-00