Software Problems - MUTOH ValueCut II VC2-600 User Manual

Trouble Shooting

7.4 Software Problems

If you are using FlexiSTARTER ValeuCut Edition, see 8.12 Troubleshooting. If you are using other
software, check the points below to solve the problem.
Is your software compatible with your computer and ValueCut?
Does your software support HP-GL and HP-GL/2 drivers?
(* check the configuration settings of your software.)
Does the cutting plotter interface
match the requirements of your
software?
Yes
Does your
software
recommend using
a different cable?
Yes
Try using the
recommended
cable.
Re-power on the cutting
plotter and try to send
the file again.
Yes
No
Refer to Chapter 2 -
Connecting your
cutting plotter.
No
Does the software
vendor provide a
sample file?
Yes
If it is not compatible with your
ValueCut, use software that has HP-GL
and HP-GL/2 emulation supports and
you can chose the following three
drivers:
 A3 size: HP7475A

A1 size: HP7580A

A0 size: HP Draf Pro Exl or HP
Draf Master
No
Do something about the error
message display on LCM, or
consult your software vendor.
74
ValueCut USER MANUAL
No
VC2E-A-00