Table of Contents
Advertisement
14.
System startup using AS-i Control Tools
The Windows based software AS-i Control Tools enables an easy and clear con-
figuration of the AS-i network.
Information!
AS-i Control Tools must be installed first!
This way, the device driver is copied into the previous designed folder in AS-i Control
Tools and should be recognized automatically.
1.
Connect the device to the PC via its serial interface and the diagnostic inter-
face.
2.
Start AS-i Control Tools.
3.
Select Master | New.
4.
Choose RS232 diagnostic interface as the protocol.
5.
Select the appropriate settings (for example serial interface COM 2, station
address <auto>).
6.
Select Master | AS-i configuration.
7.
The AS-i configuration editor will be started. All detected and configured
AS-i slaves are displayed in this window.
140
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
AS-i 3.0 EtherNet/IP Gateway with integrated Safety Monitor
System startup using AS-i Control Tools
© Pepperl+Fuchs, Printed in Germany
Internet http://www.pepperl-fuchs.com
Advertisement
Table of Contents
