Installing In The Control Cabinet; Removing - Pepperl+Fuchs VBG-EN-K30-DMD-S16 Manual

5.3

Installing in the control cabinet

The AS-I/Gateway is installed in the control cabinet on 35mm DIN rails per DIN
EN 50 022.
Information!
The enclosure of the
ble for exposed wall mounting.
To install, place the unit on the upper edge of the DIN rail and then snap in the
lower edge.
-
+ +
5.4

Removing

+ - +
To remove, press the holding clamps [2] down using a screwdriver [1], press the
unit firmly against the upper rail guide and lift out.
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
AS-I/Gateway
- -
+
- + -
is made of stainless steel. The unit is also suita-
[1]
3
© Pepperl+Fuchs, Printed in Germany
Internet http://www.pepperl-fuchs.com
AS-Interface
Installation
[2]
1
2
23