Table of Contents
Advertisement
12
Commissioning Tools and Accessories
The Windows based software "AS-i Control Tools" is designed to make the com-
missioning of the AS-i/EtherNet/IP Gateway so easy as possible.
12.1
Windows software AS-i Control Tools
The Windows software "AS-i Control Tools" enables you to configure the AS-i cir-
cuit in a very comfortable way.
1. For this purpose connect the device over the RS 232 interface with a serial in-
terface of your PC.
2. Start the AS-i-Control-Tools.
3. Call the command Master | New.
4. Choose AS-i/Ethernet Gateway as protocol.
5. Do the appropriate settings. (e.g. serial bus address, AS-i circuit <1>)
6. Call the command Master | AS-i configuration.
The AS-i configuration editor will be started. All detected and projected AS-i
slaves are displayed in this window.
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
AS-i EtherNet/IP Gateway
Commissioning Tools and Accessories
Copyright Pepperl+Fuchs, Printed in Germany
141
Advertisement
Table of Contents
