Table of Contents
Advertisement
2.
General
2.1
Product information
This system manual applies to the following Pepperl+Fuchs GmbH equipment:
AS-i 3.0 EtherNet/IP Gateway, 2 Master with duplicate
address' recognition and AS-i inspector, integrated
Safety Monitor (16 release circuits)
The AS-i/Gateway with integrated Safety Monitor combines two devices in one
housing: an
The safety unit provides 4 inputs which can be defined as either EDM or as
START inputs.
Functions of the device
The EtherNet/IP Gateway serves to connect AS-i systems to the superordinate
EtherNet/IP controller.
All possibilities offered by AS-i can be used via EtherNet/IP.
Commissioning, debugging and setting up of the AS-i parameters can be accom-
plished with the use of push-buttons, the display and the LEDs, but it can also be
handled via Ethernet TCP/IP or via the diagnostic interface.
Caption
2 master: The device is a double master
Relais circuits: number of release circuits
AS-i: number of AS-i circuits
Master, power supply:
Diagnostic interface: type of the diagnostic port
Semiconductor outputs: number of semiconductor outputs
10
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
AS-i 3.0 EtherNet/IP Gateway with integrated Safety Monitor
AS-i 3.0 EtherNet/IP Gateway
VBG-EN-K30-DMD-S16 16 2
16: safety unit generates 16 independent switching signals
2: safety unit functions with two equal AS-i circuits
2: The unit contains two AS-i Masters.
VBG-EN-K30-DMD-S16
and a Safety Monitor for 2 AS-i circuits.
2
RS 232
© Pepperl+Fuchs, Printed in Germany
Internet http://www.pepperl-fuchs.com
General
Tab. 2-1.
2
16 2
Tab. 2-2.
Tab. 2-3.
Advertisement
Table of Contents
