Table of Contents
Advertisement
Please select the required AS-i circuit using the arrow buttons and the OK button.
Than you get the TEST menu.
The function is only available for AS-i masters with two AS-i circuits.
9.8.2
SLAVE TEST TOOL
Main menu || TEST || SLAVE TEST TOOL ||
This function is used to test an individual slave.
First, select the slave in the menu by entering the slave address. Confirm your
choice pressing the menu item TEST and as a result perform testing the selected
slave.
Having finisched the test, all relevant information about the slave are displayed.
An "OK" below der slave address is displayed, if the test has been successful.
Following information are displayed (if the selected slave does not support a par-
ticular funtion, the corresponding fileds in the display will be missing):
Address of the tested slave
Displaying of configuration errors (if existing)
BINARY IN: digital inputs
BINARY OUT: digital outputs
ANALOG IN: analog inputs
ANALOG OUT: analog outputs
PROJ PARAM: projected parameter
PRJ CONF: projected configuration
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
SLAVE TEST TOOL
SLAVE ADR
TEST
SLAVE ADR
OK
BINARY INPUTS
BINARY OUTPUTS
PARAM
PERM PARAM
CONFIG
PREM CONF
PARAM: current parameter
CONFIG: current configuration
Operation in advanced display mode
4
4
0 0 0 0
0 0 0 0
F
F
7BF0
7BF0
© Pepperl+Fuchs, Printed in Germany
Internet http://www.pepperl-fuchs.com
AS-Interface
101
Advertisement
Table of Contents
