Table of Contents
Advertisement
11
Commissioning Tools
The Windows based software "AS-i Control Tools" is designed to make the com-
missioning of the AS-i/PROFIBUS Gateway so easy as possible.
The software communicates with the AS-i/PROFIBUS Gateway using a PROFI-
BUS DP Master Simulator DP V1.
11.1
Windows software AS-i Control Tools
The Windows software "AS-i Control Tools" enable you to configure the AS-i cir-
cuit in a very comfortable way.
1. For this purpose plug in the PROFIBUS DP Master Simulator DP V1 or a serial
PROFIBUS Master to the D-SUB-connector of the AS-i/PROFIBUS Gateway
and connect the device via the RS 232 interface with a fully covered cable to a
serial interface of your PC.
2. Start the AS-i-Control-Tools.
3. Call the command Master | New.
4. Choose PROFIBUS as protocol.
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Commissioning Tools
Copyright Pepperl+Fuchs, Printed in Germany
133
Advertisement
Table of Contents
