Table of Contents
Advertisement
4.
Spezifications
4.1
Technical data
Attention!
The AS-I power supply for the AS-I components must have isolation per IEC 60
742 and be able to handle momentary power interruptions of up to 20 ms. The
power supply for the 24 V supply must also have isolation per IEC 60 742 and be
able to handle momentary power interruptions of up to 20 ms. The maximum out-
put voltage of the power supply must also be less than 42 V in case of a fault.
4.1.1
Data sheet VBG-EN-K30-DMD-S16
VBG-EN-K30-DMD-S16
Ethernet/IP interface
Baud rates
Serial interface
AS-i cycle time
Safety monitor
Release circuit
Start delay
Respond delay
Inputs:
4 x EDM/Start
Output:
4 x output switching elements
Card slot
Displays
LCD
LED power
LED net
LED config error
LED U AS-i
LED AS-i active
LED prg enable
LED prj mode
LED AUX
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
RJ-45
10/100 MBaud
RS 232
150 Ps
(number of slaves + 2)
*
4-channel
< 10 s
< 40 ms
EDM: inputs of external device monitoring circuits
start: start inputs
switching current statical 4 mA at 24 V, dynamic 30 mA at 24 V (T=100 µs)
relay outputs (output circuits 1 and 2)
max. contact load: 3 A AC-15 at 30 V, 3 A DC-13 at 30 V
semiconductor outputs (output circuits 3 and 4)
max. contact load: 0,5 A DC-13 at 30 V
chip card for storage of configuration data
indication of slave addresses and error messages
power on
Ethernet/IP master recognized
configuration error
AS-i voltage OK
AS-i normal operation active
automatic addresses programming enabled
configuration mode active
auxiliary power
AS-Interface
Spezifications
© Pepperl+Fuchs, Printed in Germany
Internet http://www.pepperl-fuchs.com
15
Advertisement
Table of Contents
