Table of Contents
Advertisement
7.9.3
Buttons
The buttons are used for the following:
⇑
Mode/
Set/⇓
OK
ESC/Service
For additional information see:
•
<Section <Function of the ESC/Service key>
•
<Section <Replacing a defective safety-configured AS-i slave>
•
<Section <Operation in advanced display mode>.
44
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
AS-i 3.0 EtherNet/IP Gateway with integrated Safety Monitor
Switching between configuration mode and protected operating
mode, and saving the current AS-i configuration as the nominal
configuration.
Selecting the address of and assigning an address to a slave.
Change to extended mode.
For teaching the code table for a new safe slave, when exactly one
safe slave is being replaced, and for unlocking the Safety Monitor.
This button is also used to exit extended mode.
Electrical connection
© Pepperl+Fuchs, Printed in Germany
Internet http://www.pepperl-fuchs.com
Advertisement
Table of Contents
